NewNot sure which service you need? Answer four quick questions. Try the Service Finder

Design tool

Enclosure heat-rise calculator for 3D printed boxes

Find out how hot the electronics inside a 3D printed enclosure will get, before you print it. The calculator models the printed walls, every face of the box, vents or a fan, sunshine and on/off duty cycles, then checks the result against the filament's heat limit and your components.

1What is inside

Example values only: enter the real power and limits of your parts.

Heat produced inside

W
mm
mm
g
g
°C
2The enclosure
mm
mm
mm
mm

How it is mounted

3How the walls are printed
×
×
%
mm
mm

Air trapped in the infill insulates. The calculator builds each wall from solid loops, solid shells and the infill between them.

4Ventilation
5Where and how it runs
°C
m

How long it runs

The link in your address bar keeps your inputs, so you can bookmark or share the result.

Loading…

Checks

    Ask an engineer to design the enclosure

    Need more than an estimate? For enclosures with fans, heat sinks, complex vents or tight temperature limits, we run a CFD thermal simulation of your CAD model: airflow, hot spots and the temperature of each component. Part of our product development support.

    Ask about a CFD simulation

    An enclosure is not one number

    Most calculators use one coefficient

    The usual quick formula divides the power by the surface area and a single heat-transfer coefficient. It ignores how heat gets from the electronics to the walls, which faces actually lose heat, and what happens with vents, sun or a device that switches on and off.

    This one models the path

    Electronics, inside air, each wall inside and outside, and the surroundings are linked as a network. Every face uses the heat-transfer behaviour of its orientation, the electronics radiate to the walls, and the face standing on a desk or against a wall is treated separately.

    Printed walls are different

    A printed wall is solid loops and shells with infill in between, and the air in the infill insulates. The calculator builds the wall from your slicer settings and from conductivity measured on printed filament samples.

    Vents, fans and sun

    Openings low and high create a chimney: the warm air rises and leaves at the top. The calculator balances that lift against the resistance of your openings, grilles and filters, or finds where a fan's curve meets them. In the sun, the colour of the box sets how much heat it absorbs.

    On/off devices

    A device that runs 10 minutes every hour never reaches its steady temperature. The calculator simulates the cycles, including the heat stored in the electronics, batteries and walls, and reports the real peak.

    Material and parts

    The hottest wall is compared with the filament's heat deflection temperature from Bambu Lab's data sheets, and the stiffness left in screw bosses and clips. Batteries, capacitors and touch temperatures are checked against published limits.

    Limits. This is a design estimate, not a measurement or certification. It assumes still air outside (no wind), a well-mixed air volume inside and evenly spread heat on the board; individual hot components with their own heatsinks run hotter than the board average shown. Some wall conductivities and the vent and filter losses are engineering estimates. For products that must meet a safety standard, measure a prototype. For airflow detail and local hot spots, ask us about a CFD simulation.

    More tools: the snap-fit calculator, the gear generator or all our design tools.

    Need an enclosure that stays cool?

    Send us the board, the power and where it will be used. We design the enclosure, vents and mounting, choose the material and print it.

    Ask for a Design Review
    Chat on WhatsApp