NewNot sure which service you need? Answer four quick questions. Try the Service Finder

Design tool

Screw boss & insert designer for 3D printed parts

Choose how the screw goes in (heat-set insert, thread-forming screw, captive nut or printed thread) and get the hole and boss sizes for CAD, how much load it holds, what breaks first, how tight to screw it and how to print it. It accounts for the layer direction, wall loops and infill of a printed part, and compares all four methods for your load. Download the boss as STEP or STL.

1Fastening

How the screw holds

mm
mm
mm
mm
mm

2Boss and printing

Direction of the screw when printing

mm
mm
#
mm
%
mm

An upright boss is pulled apart across its layers where it meets the wall: that is often weaker than the insert or thread itself. Ribs and a rounded base help most.

3Load and use
N
°C
#

10 N ≈ 1 kg. The load is the force trying to pull the screw out (for example the weight hanging on it, or what the parts push apart with). A bigger safety margin is applied for vibration.

The link in your address bar keeps your inputs, so you can bookmark or share the design.

Loading material data…

Model this in CAD

Download the boss

What breaks first

    Tightening

      All four methods for this job

      Print settings

        Checks

          Ask an engineer to review the fastening

          A printed boss is not a moulded boss

          Most guides give one table

          Insert makers publish a hole size; moulding guides give "hole 0.8 × D, boss 2.5 × D". Both assume a solid, uniform plastic. A printed boss is loops of plastic stacked in layers, with infill inside, and it is much weaker across the layers than along them.

          Every way it can fail

          The designer works out each failure on its own: the insert pulling out or spinning, the thread stripping, the nut punching through, and the boss itself tearing off across its layers where it meets the wall. The weakest one decides, and it is shown on the drawing.

          Layer direction

          A thread-forming screw spreads the hole as it cuts. In an upright boss that stretch runs along the printed lines; in a boss printed lying down it pulls the layers apart, which is why horizontal screw bosses split. The calculation uses the measured strength in each direction.

          Calibrated on real tests

          Strength across the layers comes from Bambu Lab's data sheets for each grade. The method is checked against published pull-out and torque tests of M3 inserts and screws in PLA, and the hole oversize against published hole-size tests.

          Tightening and time

          Plastic slowly relaxes under a screw, more as it gets warmer. The designer gives a tightening torque with margin to stripping and estimates how much clamping force is left after a year at your temperature.

          Four methods compared

          For your size, load and material, all four methods are worked out side by side: how much each holds, how tight it can be screwed, how often it can be taken apart. Pick the one that fits, then download the boss.

          Limits. This is a design estimate for axial pull-out and tightening, not a certification. It does not cover side loads, bending of the boss, fatigue, or creep rupture over years, and several factors are IMECA3D engineering estimates (marked in the results). Printed holes vary between printers: print a test piece with the suggested sizes first. Load-bearing or safety-relevant joints need testing.

          More tools: the snap-fit calculator, the heat-rise calculator, or all our design tools.

          Need the whole part designed for assembly?

          Send us the part and how it is assembled. We choose the fasteners, design the bosses, ribs and inserts, and print and test the parts.

          Ask for a Design Review
          Chat on WhatsApp